Lovable

Lovable builds apps from a conversation. Connect it and the Coder can see your projects and draft a change as a link that opens your project's chat with the request already typed in. You press send in Lovable, so nothing is built until you do.

At a glance#

What assistants can do#

Setup (when it opens)#

1. In Lovable, open your workspace settings, then access tokens, and create a token with the permissions listed below. An owner or admin of the workspace creates it.
2. Open Integrations and pick Lovable.
3. Paste the token and press Connect.

Permissions#

In plain words, the token needs to:

• Read the workspace, so the Coder can list projects.
• Read and write projects, so the Coder can publish one.

If you only want the Coder to list projects and draft changes, you can leave out the ability to write.

Good to know#

• The Coder never starts the work itself. It gives you a link, and you press send in Lovable.
• Publishing waits for your Approve, unless your house rules allow it.
• Deleting, unpublishing, and archiving are never offered. Do those in Lovable.
• If your token has an address allowlist in Lovable, the Coder's workspace may be blocked. Remove the allowlist for this token, or add the address your assistants connect from.
• Your token stays with your StellarFirm workspace and is never shown back to you. The page shows only that it is connected.

Prompts#

Coder, list my Lovable projects and say which ones were changed most recently.

Coder, draft this change for the [project] project and give me the editor link: [change]. Do not publish until I Approve.

Coder, publish the [project] project once I Approve, then tell me whether the publish finished.